Seeflex 060ES | BFM® Fitting
Superior to traditional hose clamped canvas/cloth/rubber connectors
Seeflex 060ES is a clear, ether-based thermoplastic polyurethane alloy connector with an internal polyester scrim. The internally bonded scrim restricts the Seeflex sleeve from stretching and provides superior pressure resistance.
Use the BFM® Seeflex 060ES connector only for overpressure situations for continuous pressure up to 1.3 bar (tested on a static 200mm diameter x 200mm long connector *). Seeflex 060ES should not be used where the connector is intended to act as a pressure-release point.
* Engineering adjustments should be made for changes in diameter. Contact us for length adjustments or non-static applications.
Physical Properties
Base Fabric: Ether-based thermoplastic polyurethane
Scrim: Polyester
Wall thickness (+/- 10%): 1.3mm / 3/64”
Tensile Strength (MPa): 47
Tear Strength (MPa): 111
Max Operating Temp: 120˚C / 248˚F
Low Temp Flexibility: Good
Max. Operating Pressure (for temp. to 90˚C / 195˚F)**: 1.31 bar / 19 PSI
Elongation (100%): 12.5
Elongation (300%): 16.0
Ultimate Elongation (%): 382
Weight: 1,220 g/m2 , 43 oz/yd2
Permeability: 0
Key Features/Uses
-
The BFM® Seeflex 060ES connector is only used for overpressure situations for continuous pressure up to 1.3 bar (tested on a static 200mm diameter x 200mm long connector *)
-
IMPORTANT NOTE: Seeflex 060ES is designed to resist extremely high pressure and therefore it should not be used where the connector is intended to act as a pressure-release point
Available Sizes
Diameters: Ø100mm (4"), Ø125mm (5"), Ø150mm (6") through to Ø1,650mm (65") in 50mm (2") increments
Lengths: 80mm (3"), 100mm (4") then in 50mm (2") increments up to 1,000mm (3ft 3")
Complies With
Seeflex complies with the following regulations: FDA 21 CFR 177.1680 & 177.2600, USDA & 3A (20-), (EC) 1935/2004, 2023–2006 & 10/2011