VAS - Polypropylene Ball Valves - Angle Stop | LIQUIfit™

LIQUIfit’s corrosion-resistant, all plastic design makes the valves ideal for water filtration units, coffee and beverage machines, plus a wide variety of other fluid applications.
The polypropylene material meets all FDA and NSF-51 requirements for food contact.

vas-valve-angle-stop.jpg
 
vas-specs.jpg
  • Working Pressure: 150 PSI
  • Temperature Range: +35°F to +200°F
  • O-Ring Seal Material: EPDM
  • NSF-51 Listed, FDA Approved

Return to Thermoplastic Ball Valves Product Selection Page

Part No.

Tube O.D.

Male Thd.
Female Thd.

A

B

C

D

E

F

LFPP4VAS6 1/4 3/8 3/8 1.95 1.24 2.17 1.11 1.41 .91
LFPP4VAS8 1/4 3/8 1/2 1.95 1.24 2.40 1.11 1.41 .91
LFPP6VAS6 3/8 3/8 3/8 2.06 1.35 2.17 1.11 1.41 .91
LFPP6VAS8 3/8 3/8 1/2 2.06 1.35 2.40 1.11 1.41 .91

Assembly Instructions:

  1. Inspect the mating threads for debris or damage. Remove any old fluoropolymer tape or sealant on previously used threads.
    If threads are damaged, use a new adapter before proceeding.
  2. Apply 2 to 3 wraps of fluoropolymer tape or an NSF/FDA approved silicone sealant.
    Do not use Plumbers Putty or Pipe Dope. These chemically react with plastic materials and could cause a failure.
  3. Align ball valve onto mating thread to ensure cross threading does not occur.
  4. Screw ball valve onto mating thread 3 to 5 turns. Do not over-tighten
  5. Pressurize the system and check for leaks.