1-833-300-2114

Increase your hose assembly service life by avoiding routing mistakes

Here are six quick tips on the correct routing of hose assemblies. They are simple, common sense principles that can prolong your hose's service life and prevent hose failure.

Avoid twisting assembliesAvoid twisting assemblies

Bending a hydraulic hose assembly in more than one plane causes twisting of its wire reinforcement. A  twist of five degrees can reduce the service life of a high-pressure hydraulic hose by as much as 70%. A seven degree twist can result in a 90% reduction in service life.

 

Hose bend radius too tightDo not bend hoses tightly

Allow ample bend radius to avoid hose collapse of the line and restriction of flow. Never bend the hose tighter than the minimum bend radius specified by the hose’s manufacturer. Assure that the bend does not start right at the fitting.

 

 

Hose bend radius too tight

Using adapters to solve routing problemsUse elbows or other adapters

Use elbows or other adapters to ensure the minimum bend radii are within limits specified by the hose’s manufacturer, to reduce needed hose length and to enable hose assemblies to be routed neater – away from harm’s way.

 

 

 

Using hose clamps to improve routingUse hose clamps

Using clamps is an important aspect of proper routing. Clamps secure the hose in its proper position and help to keep it from being pulled, hit, crushed or rubbing against surrounding moving parts.

 


 

Hose assemblies get shorter under pressurePrevent assemblies from becoming fully extended

As hose assemblies get pressurized, their diameter increases and they become slightly shorter. If a hose is permitted to assume a fully extended state, it may be too short when pressurized. The result is the hose being pulled out of the fittings. With repeated cycles, this will decrease the hose’s service life and can lead to a failure. Design at least a slight bend/slack to any hose route to prevent this from happening.

Protect assemblies from damage

Hydraulic hose manufacturers estimate that 80% of hose failures are attributable to external physical damage through pulling, kinking, crushing or abrasion of the hose. Abrasion caused by hoses rubbing against each other or surrounding surfaces is the most common type of damage.

To prevent external damage, ensure all clamps are kept secure, pay careful attention to routing whenever a replacement hose is installed and if necessary, use hoses with abrasion resistant cover and/or apply polyethylene spiral wrap to protect hydraulic hoses from abrasion.

Posted by Marek Bobik

Related Articles
Choosing Between Hose and Tube Assembly for Hydraulic Systems

Choosing Between Hose and Tube Assembly for...

When choosing between a hose assembly and tube assembly for a hydraulic application, there are a...
Read More
Parker hose layline - wealth of information

Parker hose layline - wealth of information

Have you noticed all the writing on your hoses that are manufactured by Parker Hannifin? To most...
Read More
Hydraulic Hose Solutions for Airport Ground Support Equipment

Hydraulic Hose Solutions for Airport Ground...

Parker Hannifin’s Hose Product Division recently published the White Paper titled Aviation Ground...
Read More
Improving safety of hydraulic systems by using hose restraints

Improving safety of hydraulic systems by using...

If you worked around hydraulic systems for any length of time, you have seen a hydraulic hose...
Read More