Messy Hose PileWe hear this question all the time. How long do hydraulic hose assemblies last? The bad news is that there is no simple answer to how long you should wait before replacing hose assemblies on your equipment. The good news is that there are signs that maintenance personnel can (and should) look for to determine when it's time for preventive hose assembly replacement.

Don't put old rubber hose assemblies on your equipment.

According to the Society of Automotive Engineers (SAE), the shelf life of bulk rubber hose is 10 years from the date of manufacture. Look for the manufacturing date of the hose on its lay-line and if the hose is close to 10 years old, don't use it.

Purchasing a new hose assembly is usually many times less expensive than the cost of clean up after the old hose breaks, not to mention the potential damage to different (expensive) components of your system, down time and the potential for injury.

Setup a preventive schedule - and follow it regularly.

For most applications, a simple visual inspection once a month and preventive replacement of hoses every year or two is adequate. 80% of hose failures are attributable to external physical damage through pulling, kinking, crushing or abrasion of the hose and all the external damage can typically be checked for.

Keep a log of the hose replacements - especially replacements necessitated by a hose failure. You can use this log to estimate how long your hoses last in your application. You should only use this information for budgeting purposes and never as a substitute for regular visual inspection.

Inspect/replace critical hydraulic hose assemblies more often. Critical hose assemblies may be those that are close to the equipment operators or whose failure could result in injury or would cost a great amount of damage.

IMPORTANT!  When inspecting the equipment, never touch pressurized hoses with your hands, not even with gloved hands. If you are looking for a pinhole leak, use a piece of cardboard or wood to locate it, NEVER run your hand over the hose to find it. Hydraulic oil injection injuries are very serious and can result in amputation or even death. Read our related blog on hydraulic oil injection injuries (warning - pictures are graphic).

Replace hose assemblies if you find any of the following conditions:

  • Oil leaking around fittings or along the hose
  • Crushed hoses
  • Abrasion - any exposed wire reinforcement is a sure sign of need for replacement
  • Any significant damage to the outer cover beyond scuffs and small nicks
  • Twisted hoses (may indicate a need for a swivel or different routing)
  • Kinks (may indicate incorrect routing - bend radius below minimum specified by the manufacturer)
  • Cracked or corroded fittings (red rust is cause for concern, white oxidation is acceptable)

Read related blogs:

Posted by Marek Bobik

Related Articles
Parker Catalog 4400 Correction | Parker hose 611HT Specifications

Parker Catalog 4400 Correction | Parker hose...

There is an important error in Parker Catalog 4400...
Read More
Scheduled hydraulic hose replacement saves time and money

Scheduled hydraulic hose replacement saves time...

All hydraulic hoses will fail; it’s only a matter of time. It might seem logical to replace hoses...
Read More

True Story About a Hydraulic Oil Injection Injury

We are still surprised when people who make a living maintaining hydraulic systems are totally...
Read More
Consider the hidden cost of hydraulic hoses

Consider the hidden cost of hydraulic hoses

Many buyers and maintenance managers equate the cost of a hydraulic hose assembly to its purchase...
Read More